I noticed that one of my wheel studs isn’t seated properly into the hub flange. What’s the best way to press it through? Should I just hammer it a few times or is there a better way? Thanks in advance!
As others have said, you can stack some washers and use a lug nut to pull it into place. Make sure to lubricate the threads to make it easier. I’ve done this a lot and it works well.
Put a bolt larger than the lug nut on, then use the lug nut to tighten and pull the stud through.
Get about 6 high-strength steel washers and a high-strength steel nut. Use those to pull the stud into place. Also, if the part is new, you might want to ask for a replacement or a discount.
Blake said:
Get about 6 high-strength steel washers and a high-strength steel nut. Use those to pull the stud into place. Also, if the part is new, you might want to ask for a replacement or a discount.
This is a good idea!
Ozzy said:
Bolaxin 22800 Tire Wheel Stud… [link to Amazon]
Amazon Price History:
Bolaxin 22800 Tire Wheel Stud Installer Tool
- Rating: ★★★★☆ 4.4 (7 ratings)
- Current price: $9.99
- Lowest price: $8.54
- Highest price: $11.99
- Average price: $9.47
Ozzy said:
Bolaxin 22800 Tire Wheel Stud… [link to Amazon]
I have this one. Works great!
Use a washer to spread the force under a deep socket to push against, and then use a c-clamp to bring the whole thing together.
Safe DIY Method for Seating Wheel Studs Properly
To seat wheel studs correctly, it’s best to use tools rather than hammering to avoid damaging threads or the hub flange. Here’s how:
Tools Needed:
- Large washer or socket (wide enough to fit around the stud).
- Open-ended lug nut.
- Wrench or impact driver.
- Prepare: Make sure your work area is clean and you have your tools ready.
- Position the Washer or Socket: Place the washer/socket over the stud to support it.
- Thread the Lug Nut: Screw the lug nut onto the stud, flat side facing the washer/socket.
- Tighten: Use the wrench or impact driver to tighten the lug nut, pulling the stud into the hub flange.
- Check: Keep tightening until the stud is flush with the hub flange.
- Inspect: Confirm the stud is seated properly.
Why Not Hammer?
- Hammering can damage the threads or flange.
- It may misalign the stud or damage other parts.
This method is safer and ensures a cleaner result.
Definitely don’t use a hammer. A bench vice with rags is the way to go. Don’t damage your Jeep parts like that!
You can try hammering it, but if you have an old lug nut and some washers, you can use them to pull it through. Just make sure you don’t stretch the stud when it bottoms out.